IPv6 Endpoints

This section is for those who want to access the Hoppy interface using an IPv6 or Dual IPv4/IPv6 endpoint.

WARNING

Using the Dual IPv4/IPv6 Endpoint means the interface will persist on either IPv4 or IPv6 when it is activated, i.e. clients may lose connectivity if they move from a network with IPv6 support to one without. For this reason, it is recommended to use the IPv4 endpoint, unless you are sure that your network will always support IPv6.

Steps

1. On the Modify Subscription page for your interface, click the '.conf Template' button at the bottom (next to 'Clear Private Key').

2. In the configuration template, find and copy the 'IPv6 Endpoint' or the 'Dual IPv4/IPv6 Endpoint'.

3. Replace the endpoint in your client configuration with the desired endpoint.

4. Finally start the WireGuard Interface.